Shipbucket https://111903.jhzobq.asia/forums/ |
|
Frigate https://111903.jhzobq.asia/forums/viewtopic.php?f=15&t=6063 |
Page 1 of 1 |
Author: | heuhen [ May 9th, 2015, 12:28 am ] |
Post subject: | Frigate |
Just trying out a idea on an 124,2 meter hull. with two helicopter and RHIB launch bay, etc. |
Author: | Hood [ May 9th, 2015, 8:23 am ] |
Post subject: | Re: Frigate |
Looks good. My only criticism would be that the gun looks awfully close to the bows. I'm sure you've already checked it fits, but it just looks a little tight. |
Author: | Skyder2598 [ May 9th, 2015, 8:58 am ] |
Post subject: | Re: Frigate |
nice design heuhen, like it |
Author: | heuhen [ May 9th, 2015, 10:19 am ] | ||
Post subject: | Re: Frigate | ||
Looks good. My only criticism would be that the gun looks awfully close to the bows. I'm sure you've already checked it fits, but it just looks a little tight.
Yeah it's tight fit, and I think it going to be the biggest gun for this hull, normally you would fit the 57 mm instead.
nice design heuhen, like it
thanks
|
Author: | acelanceloet [ May 9th, 2015, 10:34 am ] |
Post subject: | Re: Frigate |
even then, I wonder where your anchor winch and chain go |
Author: | heuhen [ May 9th, 2015, 10:55 am ] | |
Post subject: | Re: Frigate | |
even then, I wonder where your anchor winch and chain go
to the front, the chain room have to be high than one deck, but it deck areal would be smaller.The gun magazine size would suffer a bit, but not so much. there still plenty of room. BTW. I have seen ships with guns that far forward, and that with 5" guns... British ship anyone! But if I compare it to the Norwegian frigate, then the gun is only mounted in front of FN class gun position, compared to water line, But then FN is build to handle over 300 tons of ice on deck, and still be fully operational. |
Author: | eswube [ May 10th, 2015, 8:52 am ] |
Post subject: | Re: Frigate |
Interesting and well made. |
Author: | ezgo394 [ May 20th, 2015, 2:15 am ] |
Post subject: | Re: Frigate |
Nice looking frigate there HeuHen! |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |